MAINTENANCE

-Daily Care

1. After use, wipe off sebum and moisture with a soft cloth such as an eyeglass wipe.

2. Store in a sealed box or other container away from direct sunlight and as little air as possible.

-Products with plated finishes
（Crip / Round）

1. Wipe with a soft cloth or eyeglass wipe.
2. Add neutral detergent to lukewarm water (about 40°C) and scrub gently with a soft brush.
3. Rinse under running water to thoroughly remove the cleaning solution.
4. Wipe off the water and let it dry.

※Do not use abrasive jewelry cloths.
　The plating may come off.
※The only way to clean products made of pearl is to wipe them dry.
　Pearl is sensitive to water and may lose its luster if cared for after 2.

-Products with K10,K18,diamonds
（Slice diamond / Position)

1. Clean the metal part with a soft cloth, eyeglass wipe, or abrasive cloth.
2. Add neutral detergent to lukewarm water (about 40°C) and scrub gently with a soft brush.
3. Rinse under running water to thoroughly remove the cleaning solution.
4. Wipe off any moisture.

※Do not use abrasive cloths on products with a matte finish.

-Products with pearl,K10,K18
（Twin / Dent / Uwajima / Baroque）

1. After use, wipe off sebum and moisture with a soft cloth such as an eyeglass wipe.
2. Store in a sealed box or other container away from direct sunlight and as little air as possible

※Pearl should not be dipped in water or warm water. They may lose their luster.

※When the pearl loses its luster, wipe it dry with a jewelry cloth specially designed for pearls.

-Products with gemstones,K10,K18
（Band / Slice)

1. Use a soft cloth, eyeglass cleaner, or abrasive cloth to clean the metal part.
2. Add neutral detergent to lukewarm water (about 40°C) and scrub gently with a soft brush.
3. Rinse under running water to thoroughly remove the cleaning solution.
4. Wipe off the water and let it dry.

※Some gemstones, such as emeralds and opals, are not suitable for the above care methods. Please check the table for details.

Water-sensitive gemstone(opal/emerald/shell etc.)

1. Clean the metal part with a soft cloth, eyeglass wipe, or abrasive cloth.

※Be careful not to scrub the stone part with abrasive cloth. It may scratch the surface.